r1ch.net forums
* Home Help Search Login Register
r1ch.net  |  r1ch.net stuff  |  R1Q2  |  Topic: conchars too small at 1440x 990.is there a way to increase size with r1q2?
Pages: [1]
Print
Author Topic: conchars too small at 1440x 990.is there a way to increase size with r1q2?  (Read 3244 times)
bigl
Guest
« on: May 10, 2007, 05:57:03 pm »

title says it all..is there a way to increase the size of the conchars....cant see tp messages anymore..they are too small..

I also remember that there was acommand to repeat the message in the middle of the screen...cant find the command thou..

help pls!
Logged
WORM.
Member

Posts: 71


« Reply #1 on: May 10, 2007, 06:10:54 pm »

//Configure HUDscale in R1Q2, adjust value as required
set gl_hudscale 1.5

//Configure Chatud in R1Q2
set scr_chathud 1
Logged
bigl
Guest
« Reply #2 on: May 10, 2007, 06:18:29 pm »

evn thouh the commands seem the right ones..apparently the only think that they change is the position of the commands.. now when I type in messages a see them in the left up corner and again the same tp message n the middle left one of the screen.
the new tp message is made of two line, each line a message and they stay there untill a new tp replace the older one and so on.

i donot know if it matters but now I am using default opengl. When set on r1q2 the video restarts and it goes in sw mode only...

thx for your help
Logged
R1CH
Administrator
Member

Posts: 2625



« Reply #3 on: May 10, 2007, 06:55:13 pm »

You need R1GL to use gl_hudscale.
Logged
bigol
Guest
« Reply #4 on: May 11, 2007, 02:38:56 am »

can u help me to make it work?...as i said if I try to set q2 on r1q2 the video restart and it gos in sw mode only. While on default opengl or nocheat opengl is fine..
Logged
bigl
Guest
« Reply #5 on: May 11, 2007, 03:05:44 am »

sorted..sorry about the dump question...i just did not put in the right dir r1gl files....

thx for helping
Logged
Pages: [1]
Print
r1ch.net  |  r1ch.net stuff  |  R1Q2  |  Topic: conchars too small at 1440x 990.is there a way to increase size with r1q2?
Jump to:  

Powered by SMF 1.1.19 | SMF © 2013, Simple Machines